Draper CSM355 Petunjuk Manual - Halaman 8
Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Melihat Draper CSM355. Draper CSM355 16 halaman. 355mm dry metal cutting saw
Halaman Cetak
OPERATION AND USE
ON - OFF SWITCH:
To turn the saw "ON" push in on switch lock key
✮✌ and depress switch trigger ✯✌. To turn the
saw "OFF" release switch trigger ✯✌. Fig.4.
LOCKING SWITCH IN THE "OFF"
POSITION:
IMPORTANT:We suggest that when the machine
is not in use, the switch be locked in the "OFF"
position using a padlock (Draper Stock No.64164)
✰✌ through the holes in the switch trigger ✯✌.
Fig.5.
ADJUSTING DOWNWARD TRAVEL OF BLADE:
The stop screw ✱✌ will limit the downward
travel of the blade. This is adjusted by loosening
lock nut ✳✌ and turning stop screw ✱✌ in or out
as desired. Then tighten lock nut ✳✌. Fig.6.
IMPORTANT NOTICE:-
item, always allow the blade to cut freely. Do not
force the blade through the workpiece. This will
result in poor cutting and damage to the TCT teeth.
The blade supplied is suitable for dry cutting mild
steel and angle iron. It is not capable of cutting hard
steel or stainless steel. Certain materials will require
the blade to be sharpened more frequently, for
example galvanised steel.
The arm casting ✴✌ contact with the stop screw
✱✌, limiting the downward travel of the blade
Fig.7.
NOTE: If the stop screw ✱✌ is set too low it will
cause the dust tray to be cut by blade. Always
keep the stop screw ✱✌ at a height to clear the
dust tray.
The blade is a consumable
Fig.4.
✮✌
Fig.5.
✱✌
- 7 -
✯✌
✰✌
✱✌
✳✌
✴✌
✯✌
Fig.6.
Fig.7.