Draper 20582 Manual Petunjuk Asli - Halaman 12

Jelajahi secara online atau unduh pdf Manual Petunjuk Asli untuk Kompresor Udara Draper 20582. Draper 20582 20 halaman. Cordless air compressor
Juga untuk Draper 20582: Manual (20 halaman)

Halaman Cetak

8. Operating Instructions

Important: Read all Health and Safety instructions

before using this product.

8.1 Using the Compressor

Important: ALWAYS follow the manufacturer's

recommendations for pressure levels. After inflation,

vehicle tyre pressure should ALWAYS be double-checked

using a purpose-built tyre pressure gauge complying

with BS EN 12645:2014.

Fig.

1. Attach the air hose (B) by twisting the hose

attachment (B1) clockwise into the attachment lock

(7) until it clicks until place.

Fig.

2. Press the compressor power button (2) beneath the

LCD pressure display (1).

Important: The compressor cannot be used until the

LCD display is switched on. The LCD display turns off

automatically after 30 seconds of inactivity.

3. To change the display pressure units, press the

compressor power button repeatedly until the

required units are displayed.

4. Screw the threaded hose connector (B2) onto the

valve of the item to be inflated; the current pressure

reading is shown on the display in the chosen units.

5. Use the increase (3) and decrease (4) pressure buttons

to select the desired pressure level, then wait for the

current pressure reading to be displayed.

Important: ALWAYS check and follow the

manufacturer's pressure recommendations.

For vehicles, this is often located on the inside of the

door. For bicycles, check the markings on the tyre.

Fig.

6. Slide the trigger lock (6) into the "unlocked" position.

7. Press and release the trigger (5) to inflate the item;

the compressor will stop automatically when the

chosen pressure level is reached.

Important: The compressor will continue to operate

until the trigger is pressed a second time. DO NOT

press and hold the trigger.

8. When complete, press the trigger once to switch off

the compressor then slide the trigger lock into the

"locked" position.

9. Disconnect the air hose from the item valve and

quickly replace the valve seal or cap, if required.

WARNING! The hose connector may be hot

after use. Exercise caution when detaching it

from a valve.

– 12 –

(5)

(6)