Draper 20582 Оригинальное руководство по эксплуатации - Страница 12
Просмотреть онлайн или скачать pdf Оригинальное руководство по эксплуатации для Воздушный компрессор Draper 20582. Draper 20582 20 страниц. Cordless air compressor
Также для Draper 20582: Руководство (20 страниц)
Печатать страницу
8. Operating Instructions
Important: Read all Health and Safety instructions
before using this product.
8.1 Using the Compressor
Important: ALWAYS follow the manufacturer's
recommendations for pressure levels. After inflation,
vehicle tyre pressure should ALWAYS be double-checked
using a purpose-built tyre pressure gauge complying
with BS EN 12645:2014.
Fig.
6
1. Attach the air hose (B) by twisting the hose
attachment (B1) clockwise into the attachment lock
(7) until it clicks until place.
Fig.
7
2. Press the compressor power button (2) beneath the
LCD pressure display (1).
Important: The compressor cannot be used until the
LCD display is switched on. The LCD display turns off
automatically after 30 seconds of inactivity.
3. To change the display pressure units, press the
compressor power button repeatedly until the
required units are displayed.
4. Screw the threaded hose connector (B2) onto the
valve of the item to be inflated; the current pressure
reading is shown on the display in the chosen units.
5. Use the increase (3) and decrease (4) pressure buttons
to select the desired pressure level, then wait for the
current pressure reading to be displayed.
Important: ALWAYS check and follow the
manufacturer's pressure recommendations.
For vehicles, this is often located on the inside of the
door. For bicycles, check the markings on the tyre.
Fig.
8
6. Slide the trigger lock (6) into the "unlocked" position.
7. Press and release the trigger (5) to inflate the item;
the compressor will stop automatically when the
chosen pressure level is reached.
Important: The compressor will continue to operate
until the trigger is pressed a second time. DO NOT
press and hold the trigger.
8. When complete, press the trigger once to switch off
the compressor then slide the trigger lock into the
"locked" position.
9. Disconnect the air hose from the item valve and
quickly replace the valve seal or cap, if required.
WARNING! The hose connector may be hot
after use. Exercise caution when detaching it
from a valve.
– 12 –
EN
(5)
(6)