Draper 20582 Оригинальное руководство по эксплуатации - Страница 10
Просмотреть онлайн или скачать pdf Оригинальное руководство по эксплуатации для Воздушный компрессор Draper 20582. Draper 20582 20 страниц. Cordless air compressor
Также для Draper 20582: Руководство (20 страниц)
Печатать страницу
7. Preparing the Air Compressor
Important: Charge the compressor for five hours before
first use.
7.1 Charging the Battery (230V)
(10)
Fig.
1
(11)
Fig.
2
1. If installed, remove the battery from the base of the
compressor by pressing the battery release button
(10) and pulling the battery (11) downwards.
(G)
Fig.
3
2. Insert the 230V adaptor (G) pin into the battery pack
and connect the plug to a 230V mains power socket.
3. The charging status is indicated by the LED on the
charging adaptor:
− Red LED: The battery is charging.
− Green LED: The battery is fully charged.
4. Disconnect the 230V adaptor and insert the battery
back into the compressor, ensuring it locks into place.
Charging may take up to three hours. The compressor
should run for approximately 15 minutes on a full charge.
Important: To preserve the battery health, Draper Tools
recommends that the compressor charging time does
not exceed five hours.
7.2 Using the 12V DC In-Car Adaptor
Important: The 12V adaptor is not a battery and can
only be used with an active power supply. Unravel the
cord fully before use. Always ensure that the cable runs
through the hole at the base of the adaptor.
1. If installed, remove the battery from the base of the
compressor by pressing the battery release button
(10) and pulling the battery (11) downwards
(Fig. 1–2).
Fig.
4
2. Insert the 12V DC in-car adaptor (F) into the base of
the compressor, ensuring it locks into place.
– 10 –
EN