- ページ 10

エアーコンプレッサー Draper 20582のPDF オリジナル取扱説明書をオンラインで閲覧またはダウンロードできます。Draper 20582 20 ページ。 Cordless air compressor
Draper 20582 にも：マニュアル (20 ページ)

7. Preparing the Air Compressor

Important: Charge the compressor for five hours before

first use.

(10)

Fig.

(11)

Fig.

1. If installed, remove the battery from the base of the

compressor by pressing the battery release button

(10) and pulling the battery (11) downwards.

(G)

Fig.

2. Insert the 230V adaptor (G) pin into the battery pack

and connect the plug to a 230V mains power socket.

3. The charging status is indicated by the LED on the

charging adaptor:

− Red LED: The battery is charging.

− Green LED: The battery is fully charged.

4. Disconnect the 230V adaptor and insert the battery

back into the compressor, ensuring it locks into place.

Charging may take up to three hours. The compressor

should run for approximately 15 minutes on a full charge.

Important: To preserve the battery health, Draper Tools

recommends that the compressor charging time does

not exceed five hours.

7.2 Using the 12V DC In-Car Adaptor

Important: The 12V adaptor is not a battery and can

only be used with an active power supply. Unravel the

cord fully before use. Always ensure that the cable runs

through the hole at the base of the adaptor.

1. If installed, remove the battery from the base of the

compressor by pressing the battery release button

(10) and pulling the battery (11) downwards

(Fig. 1–2).

Fig.

2. Insert the 12V DC in-car adaptor (F) into the base of

the compressor, ensuring it locks into place.

– 10 –