Draper 65958 Petunjuk Manual - Halaman 4
Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Kompresor Udara Draper 65958. Draper 65958 12 halaman. 12v mini air compressor
WARNING:
Please read the following instructions carefully failure to do so could lead to serious
personal injury.
IMPORTANT:
Draper Tools recommends that this compressor should not be modified or used for any
application other than that for which it was designed. If you are unsure of it's relative
applications do not hesitate to contact us in writing and we will advise you.
1. KNOW YOUR COMPRESSOR
Before operating the compressor,
read and fully understand the
starting, operating and stopping
sections in this manual. Read all
labels affixed to the compressor.
Learn it's applications and
limitations.
2. SERVICING AND MAINTENANCE
Do not service or maintain this
compressor until you have read and
understood the maintenance section
of this manual.
3. CHECK DAMAGED PARTS
Before further use of this
compressor, parts that are damaged
should be carefully checked to
ensure that it will operate correctly
and perform its intended function.
Check for alignment of moving
parts, breakage of parts and any
other conditions that may effect its
operation. A guard or other part that
is damaged should be properly
repaired or replaced.
4. DISCONNECT FROM POWER
SUPPLY
Before servicing, maintaining or
replacing damaged parts ALWAYS
disconnect the compressor from the
power supply.
5. AVOID DANGEROUS
ENVIRONMENTS
Do not use the compressor in damp
or wet locations or expose it to rain.
Keep the work area well lit. Provide
adequate surrounding work space.
SAFETY WARNING
GENERAL SAFETY RULES FOR
AIR COMPRESSORS
6. AVOID ACCIDENTAL STARTING
Make sure the power supply is off
before connecting to the power
supply.
7. NEVER LEAVE THE
COMPRESSOR RUNNING
UNATTENDED
Turn the power supply off. Do not
leave the compressor until it comes
to a complete stop.
8. USE RECOMMENDED
ACCESSORIES
Only use the recommended
adaptors as supplied.
9. OVERHEATING.
Operation over an extended period
of time will overheat the unit and
damage the compressor. When this
occurs stop the unit immediately
and do not restart until cool,
approximately 30 minutes.
10. KEEP CHILDREN AWAY
Ensure the compressor is stored out
of reach of small children.
11. TYRE PRESSURE
The gauge on the compressor is
intended as a guide only. Tyre
pressures should be regularly
checked against a tyre pressure
gauge manufactured to BS 4613,
such as Draper Stock No.26443.
- 3 -