Draper 65958 사용 설명서 - 페이지 4

{카테고리_이름} Draper 65958에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper 65958 12 페이지. 12v mini air compressor

페이지 인쇄

WARNING:

Please read the following instructions carefully failure to do so could lead to serious

personal injury.

IMPORTANT:

Draper Tools recommends that this compressor should not be modified or used for any

application other than that for which it was designed. If you are unsure of it's relative

applications do not hesitate to contact us in writing and we will advise you.

1. KNOW YOUR COMPRESSOR

Before operating the compressor,

read and fully understand the

starting, operating and stopping

sections in this manual. Read all

labels affixed to the compressor.

Learn it's applications and

limitations.

2. SERVICING AND MAINTENANCE

Do not service or maintain this

compressor until you have read and

understood the maintenance section

of this manual.

3. CHECK DAMAGED PARTS

Before further use of this

compressor, parts that are damaged

should be carefully checked to

ensure that it will operate correctly

and perform its intended function.

Check for alignment of moving

parts, breakage of parts and any

other conditions that may effect its

operation. A guard or other part that

is damaged should be properly

repaired or replaced.

4. DISCONNECT FROM POWER

SUPPLY

Before servicing, maintaining or

replacing damaged parts ALWAYS

disconnect the compressor from the

power supply.

5. AVOID DANGEROUS

ENVIRONMENTS

Do not use the compressor in damp

or wet locations or expose it to rain.

Keep the work area well lit. Provide

adequate surrounding work space.

SAFETY WARNING

GENERAL SAFETY RULES FOR

AIR COMPRESSORS

6. AVOID ACCIDENTAL STARTING

Make sure the power supply is off

before connecting to the power

supply.

7. NEVER LEAVE THE

COMPRESSOR RUNNING

UNATTENDED

Turn the power supply off. Do not

leave the compressor until it comes

to a complete stop.

8. USE RECOMMENDED

ACCESSORIES

Only use the recommended

adaptors as supplied.

9. OVERHEATING.

Operation over an extended period

of time will overheat the unit and

damage the compressor. When this

occurs stop the unit immediately

and do not restart until cool,

approximately 30 minutes.

10. KEEP CHILDREN AWAY

Ensure the compressor is stored out

of reach of small children.

11. TYRE PRESSURE

The gauge on the compressor is

intended as a guide only. Tyre

pressures should be regularly

checked against a tyre pressure

gauge manufactured to BS 4613,

such as Draper Stock No.26443.

- 3 -