Draper FlexShade Petunjuk Pemasangan & Pengoperasian - Halaman 4

Jelajahi secara online atau unduh pdf Petunjuk Pemasangan & Pengoperasian untuk Perabotan Dalam Ruangan Draper FlexShade. Draper FlexShade 16 halaman. Exterior clutch-operated shade
Juga untuk Draper FlexShade: Panduan Pemasangan & Pengoperasian (8 halaman), Petunjuk Instalasi (2 halaman), Petunjuk Manual (12 halaman), Petunjuk Pemasangan & Pengoperasian (11 halaman), Petunjuk Pemasangan & Pengoperasian (12 halaman), Petunjuk Pemasangan & Pengoperasian (4 halaman), Petunjuk Manual (7 halaman), Petunjuk Pemasangan & Pengoperasian (12 halaman), Petunjuk Pemasangan & Pengoperasian (16 halaman)

Exterior Motorized FlexShade

Section 3 - Remove Roller Assembly

Figure 4-A

1. Use 3 mm Hex Wrench to remove Screws from Side Channels and

Side Channel Covers

(Fig. 5-A)

Please Note: Do NOT remove the Bottom Caps from Side Channels.

2. Drill Side Channels at desired mounting points.

Figure 5-A

Remove screws from bottom of Headbox.

Remove Fascia and set aside.

Remove Quick Release Pin from Idler End of Roller Assembly.

Remove Motor

Clip

(Operator End

of Roller Assembly)

Remove Roller Assembly,

Idler End first, and

carefully set aside.

3. Mark wall or jamb and drill small pilot holes in mounting surface

Please Note: Recommended attachment of Side Channel to structure is

minimum of every 24"

4. Attach side channels to wall/structure

Figure 5-B

Figure 4-B

(61cm)

(Fig. 5-C)

Figure 5-C

J a

b M

P i

l o t

o u

n t

H o

l e

page 4 of 16

(Fig. 5-B)

Wall Mounting

Jamb Mounting