Draper FlexShade Instructions Installation & Operation - Page 4

Browse online or download pdf Instructions Installation & Operation for Indoor Furnishing Draper FlexShade. Draper FlexShade 16 pages. Exterior clutch-operated shade
Also for Draper FlexShade: Installation & Operation Manual (8 pages), Installation Instructions (2 pages), Instructions Manual (12 pages), Installation & Operation Instructions (11 pages), Instructions Installation & Operation (12 pages), Instructions Installation & Operation (4 pages), Instructions Manual (7 pages), Instructions Installation & Operation (12 pages), Instructions Installation & Operation (16 pages)

Print Page
Draper FlexShade Instructions Installation & Operation
Exterior Motorized FlexShade

Section 3 - Remove Roller Assembly

B
C
Figure 4-A

Section 4- Installing Side Channels Option

1. Use 3 mm Hex Wrench to remove Screws from Side Channels and
Side Channel Covers
(Fig. 5-A)
Please Note: Do NOT remove the Bottom Caps from Side Channels.
2. Drill Side Channels at desired mounting points.
Figure 5-A
A
B
E
A
.
®
A.
Remove screws from bottom of Headbox.
B.
Remove Fascia and set aside.
C.
Remove Quick Release Pin from Idler End of Roller Assembly.
D.
Remove Motor
Clip
(Operator End
of Roller Assembly)
E.
Remove Roller Assembly,
Idler End first, and
carefully set aside.
3. Mark wall or jamb and drill small pilot holes in mounting surface
Please Note: Recommended attachment of Side Channel to structure is
minimum of every 24"
4. Attach side channels to wall/structure
Figure 5-B
.
Figure 4-B
.
(61cm)
.
(Fig. 5-C)
Figure 5-C
J a
m
b M
P i
l o t
o u
n t
H o
l e
page 4 of 16
D
.
(Fig. 5-B)
Wall Mounting
Jamb Mounting