Bosch Benchmark HBLP451LUC Panduan Servis - Halaman 21
Jelajahi secara online atau unduh pdf Panduan Servis untuk Oven Bosch Benchmark HBLP451LUC. Bosch Benchmark HBLP451LUC 45 halaman. Built-in wall ovens
Juga untuk Bosch Benchmark HBLP451LUC: Spesifikasi (3 halaman), Panduan Instalasi (39 halaman), Panduan Instalasi (22 halaman)
Halaman Cetak
58300000181895 ARA EN A
7. Confirm that the adjustment cam on the lower hinge is correctly
positioned within the slot in the front frame and rear support
bracket located directly behind the front frame. If the hinge is fully
flat against the front frame and is resting against the side trim, the
cam should be in the correct position.
8. Re-install the three torx screws in the lower hinge.
6.2.2
Aligning the Door
Smooth operation of the door requires proper alignment of the striker
and the catch receiver. When aligned correctly, the door will smoothly
pull itself closed when the striker engages the receiver.
Figure 23 Correctly aligned left-hinge door
If the door is too high, there will be interference between the striker
and a part within the catch receiver, causing the catch receiver and
striker to contact each other in a hard crash.
If the door is slightly too high, when the closed door is pushed
downward, the door will bounce against the striker.
Figure 24 Door out of alignment - too high
Copyright by BSH Home Appliances Corporation
This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.
Door too high
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
JUNE 2014
Service Manual for Bosch Benchmark Series Built-in Wall Ovens
If the door is too low, a bump will be felt when the striker comes into
contact with the re-alignment roller within the catch receiver.
Figure 25 Door out of alignment – too low
Alignment Procedure
NOTICE
All adjustments to the door alignment are made to the lower
hinge only. The upper hinge is fixed and cannot be adjusted.
Each left or right ¼ turn of the alignment cam screw will
result in ~ ½ inch (1.5mm) movement at the door catch.
1. Open door to 135°.
2. Using a T-20 torx driver, loosen the three screws on the lower
hinge by one to two full turns.
3. Using a #2 Phillips-head screwdriver, turn the screw which
controls the alignment cam right or left ¼ turn (1mm).
Left-hinge Door
If the door is too low, turn the alignment screw to the right.
If the door is too high, turn the alignment screw to the left.
Right-hinge Door
If the door is too low, turn the alignment screw to the left.
If the door is too high, turn the alignment screw to the right.
Door too low
Page 21 of 45
800 944-2904