Bosch Benchmark Series Panduan Servis - Halaman 24

Jelajahi secara online atau unduh pdf Panduan Servis untuk Oven Bosch Benchmark Series. Bosch Benchmark Series 45 halaman. Built-in wall ovens
Juga untuk Bosch Benchmark Series: Panduan Servis (36 halaman), Panduan Instalasi (32 halaman), Panduan Referensi Cepat (4 halaman), Panduan Petunjuk Instalasi (40 halaman), Panduan Memulai Cepat dan Keselamatan (13 halaman)

Halaman Cetak

58300000181895 ARA EN A

5. Install the new latch/motor assembly, reconnecting the wires and

engaging the latch correctly with the latch support bracket.

6. Position the latch plate with the curved corners at the bottom, and

reinsert screws.

7. Restore power and test operation.

6.4

Oven High Temperature Cutout (HTC)

The resettable HTC is a normally closed 12VDC thermal switch that is

used to detect over-temperature conditions within the oven. It has a

connector that will interrupt the double line break (DLB) relay coil

voltage supply if the temperature reaches 185°C/365°F. When the

HTC switch opens, it breaks the line to the double line break (DLB)

relays, cutting off power to the elements.

With the latch plate removed, the HTC and the bracket it's mounted

on are visible to the left of the door latch/motor assembly. The photo

below shows the HTC and bracket, but note that this view is looking

from the rear of the oven towards the front, beneath the top plenum.

Figure 33 HTC and mounting bracket

This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.

JUNE 2014

6.4.1

Always troubleshoot a tripped HTC to determine the underlying cause

of the interruption.

To reset the HTC...

1. Remove power to the oven.

2. Insert a flat blade screwdriver through one of the vent slots, and

depress the red reset button.

3. Restore power and test operation.



NOTICE

The HTC switch should only be reset once or twice before being

replaced. The switch weakens each time it trips, so it will become

easier and easier for the switch to trip during high-temperature cycles

(i.e., Self-clean) if it has weakened over time.

To remove the HTC from the front, a right-angled screwdriver will

be needed....

1. Remove power to the oven.

2. Remove the latch plate and remove or slide the latch/motor

assembly aside as described in the Replacing the Latch/Motor

Assembly section.

3. Using a right-angled screwdriver, remove the two screws securing

the HTC to its mounting bracket.

 If it is not possible to complete step 3 from the front,

 If the screws were successfully removed, skip to step 9.

4. Remove the screws securing the right and left side trim pieces to

the cabinetry, and set screws aside.

1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614

Service Manual for Bosch Benchmark Series Built-in Wall Ovens

Resetting and Replacing the HTC

continue with step 4.

Page 24 of 45

800 944-2904