Bosch Benchmark Series Panduan Servis - Halaman 26

Jelajahi secara online atau unduh pdf Panduan Servis untuk Oven Bosch Benchmark Series. Bosch Benchmark Series 45 halaman. Built-in wall ovens
Juga untuk Bosch Benchmark Series: Panduan Servis (36 halaman), Panduan Instalasi (32 halaman), Panduan Referensi Cepat (4 halaman), Panduan Petunjuk Instalasi (40 halaman), Panduan Memulai Cepat dan Keselamatan (13 halaman)

Halaman Cetak

58300000181895 ARA EN A

6.5.1

Replacing the Front Panel Assembly

1. Remove power to the oven.

2. Protect the top of the oven door to prevent damage to the

stainless front panel or door.

3. Remove two screws on the underside of the panel assembly –

one on the right and one on the left – which secure the panel to

the vent trim; it is not necessary to remove the center screw at this

time.



NOTICE

Use care when detaching the front panel. There may be little slack in

the wires connecting the control module to the display board and the

control module to the touch pad, so it may not be possible to fully

rotate the front panel 90°.

4. Carefully swing the bottom of the control panel outward, then lift to

disengage the side flanges of the front panel carrier from the slots

in the side trim.

Figure 36 Detaching the control panel from the side trims

5. Disconnect the ground wire and the communication harness

connectors at the display board and touch pad; set the front panel

on a flat work surface.

This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.

JUNE 2014

6. Remove the screw in the bottom center of the panel, which

secures the panel to the carrier directly behind it.

7. Separate the carrier from the front panel assembly.

Figure 37 Front panel assembly (top) separated from carrier (bottom) with display module attached

8. Reassemble the control panel using the new front panel service

assembly.

9. Reattach the control panel, restore power, and test operation.

6.5.2

The display module is mounted to the control panel carrier by four

tabs that protrude from the carrier. The tabs are twisted slightly after

mounting the board to secure the board in place.

Figure 38 Display board secured to carrier with the carrier's 4 metal tabs that are twisted slightly

1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614

Service Manual for Bosch Benchmark Series Built-in Wall Ovens

Replacing the Display Module

Page 26 of 45

800 944-2904