Bosch Benchmark Series Panduan Servis - Halaman 28

Jelajahi secara online atau unduh pdf Panduan Servis untuk Oven Bosch Benchmark Series. Bosch Benchmark Series 45 halaman. Built-in wall ovens
Juga untuk Bosch Benchmark Series: Panduan Servis (36 halaman), Panduan Instalasi (32 halaman), Panduan Referensi Cepat (4 halaman), Panduan Petunjuk Instalasi (40 halaman), Panduan Memulai Cepat dan Keselamatan (13 halaman)

Halaman Cetak

58300000181895 ARA EN A

5. Support the lens and repeat step 4 with the second clip; carefully

slide the lens out and set aside; do not force the lens out – it

should detach easily.

6. Pull the halogen bulb from its socket; if it is difficult to grasp the

bulb using one hand, use both forefingers to pinch behind the

rounded part of the bulb, then pull the bulb out using both hands.



NOTICE

Any surface contamination from the oil of fingers or hands can cause

damage to halogen bulbs and premature failure. Direct contact with

the bulb should be avoided. Always hold a halogen bulb with a dry

cloth or clean paper towel.

7. Grasp the new bulb with a clean, dry cloth. Align the bulb prongs

with the socket holes and press into place.

Figure 41 Insert the prongs on the new halogen bulb into the holes in the socket

8. Reinstall the glass lens cover by inserting it into the mounting clips

and gently pressing the end of each clip until it snaps in place and

secures the lens.

9. Restore power to the oven and test operation.

6.6.2

Replacing the Lamp Receptacle Assembly

The lamp receptacle assembly service part includes the receptacle,

glass lens and halogen bulb.

This material is intended for the sole use of BSH authorized persons and may contain confidential and proprietary information. Any unauthorized review, use, copying, disclosure, or distribution in any format is prohibited.

JUNE 2014

1. Turn off power to the oven at the main power supply (fuse box or

breaker box).

2. Remove oven racks to provide access to the light lens and

halogen bulb.

3. Optional: on ovens with bottom-hinge doors, the door may be

removed to provide easier access and visibility.

4. Remove the screw securing the receptacle to the cavity side wall.

Figure 42 Removing the light receptacle

5. Carefully pull the receptacle away from the cavity wall, until the

wire plug can be disconnected from the main harness; be careful

not to drop the main harness wires.

Figure 43 Lamp receptacle assembly

6. Install the new lamp receptacle.

7. Restore power and test operation.

1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614

Service Manual for Bosch Benchmark Series Built-in Wall Ovens

Page 28 of 45

800 944-2904