Bosch FAP-OC 500Series Panduan Penggunaan dan Perawatan / Petunjuk Pemasangan - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Penggunaan dan Perawatan / Petunjuk Pemasangan untuk Oven Bosch FAP-OC 500Series. Bosch FAP-OC 500Series 40 halaman. Built-in wall ovens
Juga untuk Bosch FAP-OC 500Series: Panduan Petunjuk Instalasi (21 halaman), Petunjuk Penggunaan Manual (40 halaman), Panduan Instalasi (6 halaman), Informasi Produk (40 halaman), Panduan Instalasi (28 halaman), Panduan Pengguna (48 halaman), Panduan Pengguna (48 halaman), Panduan Instalasi (28 halaman), Panduan Penggunaan dan Perawatan (44 halaman), Panduan Instalasi (32 halaman), Panduan Referensi Cepat (4 halaman), Panduan Penggunaan dan Perawatan (27 halaman), Panduan Instalasi (24 halaman), Panduan Instalasi (32 halaman), Panduan Penggunaan dan Perawatan (24 halaman), Panduan Instalasi (28 halaman), Panduan Servis (41 halaman), Panduan Penggunaan dan Perawatan (21 halaman), Panduan Instalasi (32 halaman), Panduan Servis (36 halaman), Panduan Instalasi (32 halaman), Panduan Memulai Cepat dan Keselamatan (13 halaman)

Bosch FAP-OC 500Series Panduan Penggunaan dan Perawatan / Petunjuk Pemasangan
Only use the new water supply hose shipped with your
washer. Never use old used hoses.
The water supply hoses must not be kinked, bent, or
pinched causing hose damage or restricting water
flow.
The water supply pressure must be between 14,5 to
145 psi (1 - 10 bar) with a minimum of 2.2 U.S. gallons
(8 liters) of flow per minute. A pressure regulator valve
must be installed if the maximum water pressure is
exceeded.
Make sure the water supply faucet is easily accessible
when the washer is in use. The faucet should be
turned off if the washer is going to be unused for
extended periods of time.
Make sure rubber washers are in place at both ends of
the water supply hose. Missing washers could cause
leaks.
The connection points are under full water pressure.
Turn on the water tap and check for leaks.
Periodically inspect the water supply hose and replace
with a new hose if cuts, kinks or leaks are observed.
Water connection hoses
blue - Cold water-hose
red - Hot water-hose
14
Attach this end to water tap. Hand tighten only.
Attach this end of the hose to the back of the washing
machine as shown in the following pictures. Be sure to
use clamps and route hoses as instructed. Hand
tighten only.
Position hoses as shown when routing hoses to right
side of washer (facing from front