Bosch FAP-OC 500Series Manual de utilização e cuidados / Instruções de instalação - Página 14

Only use the new water supply hose shipped with your

▯

washer. Never use old used hoses.

The water supply hoses must not be kinked, bent, or

▯

pinched causing hose damage or restricting water

flow.

The water supply pressure must be between 14,5 to

▯

145 psi (1 - 10 bar) with a minimum of 2.2 U.S. gallons

(8 liters) of flow per minute. A pressure regulator valve

must be installed if the maximum water pressure is

exceeded.

Make sure the water supply faucet is easily accessible

▯

when the washer is in use. The faucet should be

turned off if the washer is going to be unused for

extended periods of time.

Make sure rubber washers are in place at both ends of

▯

the water supply hose. Missing washers could cause

leaks.

The connection points are under full water pressure.

▯

Turn on the water tap and check for leaks.

Periodically inspect the water supply hose and replace

▯

with a new hose if cuts, kinks or leaks are observed.

Water connection hoses

blue - Cold water-hose

▯

red - Hot water-hose

▯

Attach this end to water tap. Hand tighten only.

Attach this end of the hose to the back of the washing

machine as shown in the following pictures. Be sure to

use clamps and route hoses as instructed. Hand

tighten only.

Position hoses as shown when routing hoses to right

side of washer (facing from front