Electrolux EPPWEHGFB Manual - Halaman 20

Jelajahi secara online atau unduh pdf Manual untuk Mesin cuci Electrolux EPPWEHGFB. Electrolux EPPWEHGFB 28 halaman.

Electrolux EPPWEHGFB Manual
There is also a (plugged) hole "O" (Ø 22 mm) available
for introduction of detergent.
Electrical connections for automatic detergent and
additive dispensers.
Terminals are available on the power supply terminal
board for the electrical connection of external dispen-
sers working at 220-240 V. Max. power 30 VA.

Figure 18 Detergent dispenser terminal block

Connect the detergent dispenser between termi-
nals 7 and 9. These connection points are live for a
set time during filling of the tank and at the start of
the wash cycle (see paragraph H4 "Setting the
dispenser").
Adding the detergent (for models without auto-
matic dispenser).
Pour a non-foaming detergent into the tank when the
water has reached optimal washing temperature.
MANUAL ACTIVATION
Whenever the detergent containers are replaced, it
may be necessary to activate the dispensers manually
in order to fill the hoses and eliminate any air. Simulta-
neously press the buttons, as shown in the figures
below. If necessary, repeat this operation several
times.
DETERGENT DISPENSER
H4
Setting the dispenser
All operations should be carried out with the appliance
switched on but no cycle selected.
Press the On/Off button ("A" - Table 2 "Control panel")
and Wash cycle 1 button ("G" - Table 2 "Control panel")
together for 5 seconds, to access the programming
mode and the display shows the parameter "
22
Press the button ("N" - Table 2 "Control panel") twice to
access the detergent and rinse aid adjustment para-
meters.

Adjust the following parameters:
Function
Initial amount of detergent
Amount of detergent during
the cycle
(*) The values given in the table refer to the factory-
settings.
using the Wash cycle 1 button ("G" - Table 2 "Control
panel") to decrease the value, the Wash cycle 2 button
("H" - Table 2 "Control panel") to increase the value
and the button ("N" - Table 2 "Control panel") to con-
firm the set value. To go to the next parameter, press
the Wash cycle 2 button ("H" - Table 2 "Control panel").
For example, to adjust the parameter
as follows:
access the parameter

adjust the activation time:


".
-



+
Display
Value (*)

240

16

, proceed
