Electrolux EPPWEHGFB Посібник - Сторінка 20

Переглянути онлайн або завантажити pdf Посібник для Пральна машина Electrolux EPPWEHGFB. Electrolux EPPWEHGFB 28 сторінок.

Друкувати сторінку

There is also a (plugged) hole "O" (Ø 22 mm) available

for introduction of detergent.

Electrical connections for automatic detergent and

additive dispensers.

Terminals are available on the power supply terminal

board for the electrical connection of external dispen-

sers working at 220-240 V. Max. power 30 VA.

Figure 18 Detergent dispenser terminal block

•

Connect the detergent dispenser between termi-

nals 7 and 9. These connection points are live for a

set time during filling of the tank and at the start of

the wash cycle (see paragraph H4 "Setting the

dispenser").

Adding the detergent (for models without auto-

matic dispenser).

Pour a non-foaming detergent into the tank when the

water has reached optimal washing temperature.

MANUAL ACTIVATION

Whenever the detergent containers are replaced, it

may be necessary to activate the dispensers manually

in order to fill the hoses and eliminate any air. Simulta-

neously press the buttons, as shown in the figures

below. If necessary, repeat this operation several

times.

DETERGENT DISPENSER

Setting the dispenser

All operations should be carried out with the appliance

switched on but no cycle selected.

Press the On/Off button ("A" - Table 2 "Control panel")

and Wash cycle 1 button ("G" - Table 2 "Control panel")

together for 5 seconds, to access the programming

mode and the display shows the parameter "

Press the button ("N" - Table 2 "Control panel") twice to

access the detergent and rinse aid adjustment para-

meters.



Adjust the following parameters:

Function

Initial amount of detergent

Amount of detergent during

the cycle

(*) The values given in the table refer to the factory-

settings.

using the Wash cycle 1 button ("G" - Table 2 "Control

panel") to decrease the value, the Wash cycle 2 button

("H" - Table 2 "Control panel") to increase the value

and the button ("N" - Table 2 "Control panel") to con-

firm the set value. To go to the next parameter, press

the Wash cycle 2 button ("H" - Table 2 "Control panel").

For example, to adjust the parameter

as follows:

•

access the parameter



•

adjust the activation time:











Display

Value (*)



240





, proceed

