Drayton 13616 Panduan Petunjuk Instalasi - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Termostat Drayton 13616. Drayton 13616 16 halaman. Digistat+ cf rf cylinder thermostat
Juga untuk Drayton 13616: Panduan Pengguna (2 halaman)
Halaman Cetak
To assist with commissioning or checking the system operation,
there is a positive OFF setting outside the temperature scale on the
cylinder thermostat. First adjust the minimum temperature setting
o
to 40
C as described in the user guide, then rotate the dial fully
anticlockwise for OFF.
Signal Strength
Before fixing the Digistat+C RF to the wall it is recommended to first
check the signal strength from that location.
To do this, remove the batteries, press and hold the 'set' button whilst
refitting the batteries, keep the 'set' button held and after a few
seconds the display will show 'rF' which indicates that the Digistat+C RF
is continuously sending an OFF signal to the SCR (receiver). Leave the
Digistat+C RF in position and return to view the SCR. If the red LED is
continuously flashing, this indicates a good signal. If the red LED is not
flashing, this indicates a poor signal and you need to reposition the
Digistat+C RF until the red LED is flashing.
When the signal strength has been confirmed remove the batteries to
cancel the test and follow the installation instructions.