Alen T300 Panduan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembersih Udara Alen T300. Alen T300 12 halaman. Alen t100: user guide
Juga untuk Alen T300: Panduan Pengguna (14 halaman), Panduan Pengguna (12 halaman)

Halaman Cetak

How To Replace The UV Light

Before replacing the UV light, please unplug the unit.

Lay the unit on its side and remove the screws of the UV light compartment under the base

of the unit.

Remove the screw that is holding the wire harness.

Use one or two flat tip screw drivers to depress the clip on each side of the UV light holder.

Remove the old UV light and insert the UV light into the unit, making sure not to touch the

glass part of the bulb with you bare fingers as it can lower the life of the bulb.

Place the UV light holder back over the UV light and secure the screw for the wire harness.

How To Replace The Filter

1. Push down the filter cover tab and lift the filter cover off.

2. Pull out each used filter; the T300 has two filters that

should be replaced at the same time.

3. Take the new filter out of the plastic bag; distinguish the

front side from the back side of the filter. The front side

has the black foam layer, known as the prefilter, which

should be facing out when inside the unit, insert into the

air cleaner with the arrow pointing inward.

4. Insert the bottom of the filter cover first and then snap in

the upper part of the grill.

5. RESET the filter

indicator by holding

down RESET while the

unit is ON until the

illuminated bars

disappear. To reach the

button, use a pin or

extended paperclip.