Drazice OKC 200 NTRR / BP Panduan Pengoperasian dan Pemasangan - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Pengoperasian dan Pemasangan untuk Ketel uap Drazice OKC 200 NTRR / BP. Drazice OKC 200 NTRR / BP 19 halaman. Stationary water heaters
Juga untuk Drazice OKC 200 NTRR / BP: Panduan Pengoperasian dan Pemasangan (17 halaman), Panduan Pengoperasian dan Pemasangan (12 halaman), Panduan Pengoperasian dan Pemasangan (20 halaman), Panduan Pengoperasian dan Pemasangan (20 halaman), Panduan Pengoperasian dan Pemasangan (18 halaman), Panduan Pengoperasian dan Instalasi (20 halaman), Panduan Pengoperasian dan Pemasangan (18 halaman), Panduan Pengoperasian dan Instalasi (13 halaman)

300, 400 a 500 litre capacity heaters are screwed onto the bottom wooden palette with

M12 screws. When the heater is released from the palette and prior to its putting into

operation, 3 screw legs supplied as the product accessories have to be installed. With

these adjustable legs, the heater may be positioned vertically to the base, within 10 mm.

2 OPERATION AND FITTING INSTUCTIONS

The tank shall only be used in accordance with the conditions specified on the power plate

and in instructions for electric wiring. Besides legally acknowledged national regulations and

standards, also conditions for connection defined in local electric and water works have to

be adhered to, as well as the installation and operation manual.

The temperature at the place of heater installation must be higher than +2°C; and the room

must not freeze. The appliance has to be mounted at a convenient place; it means that the

appliance must be easily available for potential necessary maintenance, repair or

replacement, as the case may be.

We would like to emphasise that the heater must not be connected to power supply if

work involving flammable liquids (petrol, spot remover) or gases, etc., is performed

nearby.

- 12 -