Drazice OKC 200 NTRR / BP Panduan Pengoperasian dan Pemasangan - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Pengoperasian dan Pemasangan untuk Ketel uap Drazice OKC 200 NTRR / BP. Drazice OKC 200 NTRR / BP 19 halaman. Stationary water heaters
Juga untuk Drazice OKC 200 NTRR / BP: Panduan Pengoperasian dan Pemasangan (17 halaman), Panduan Pengoperasian dan Pemasangan (12 halaman), Panduan Pengoperasian dan Pemasangan (20 halaman), Panduan Pengoperasian dan Pemasangan (20 halaman), Panduan Pengoperasian dan Pemasangan (18 halaman), Panduan Pengoperasian dan Instalasi (20 halaman), Panduan Pengoperasian dan Pemasangan (18 halaman), Panduan Pengoperasian dan Instalasi (13 halaman)

2.2.2 EXAMPLE OF CONNECTING A HEATER WITH SOLAR COLLECTORS AND A GAS

BOILER

Connecting a heater to a boiler heating circuit:

The heater is placed on the ground, next to the heating source, or in its vicinity. The heating circuit is

connected to marked inputs and outputs of the heater exchanger; the deaeration valve is mounted in the

highest place. It is necessary to install a filter into the circuit in order to protect the pumps, the three-way

valve, and backflow flaps, and the exchanger from sedimentation. It is recommended to flush the heating

circuit before the assembly. All wiring connections must be properly insulated from heat.

If the system works with priority heating of HSW using a three-way valve, always follow the

installation instructions of the three-way valve´s manufacturer.

Figure 5

- 14 -