Drazice OKC 200 NTRR / BP Panduan Pengoperasian dan Pemasangan - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Pengoperasian dan Pemasangan untuk Ketel uap Drazice OKC 200 NTRR / BP. Drazice OKC 200 NTRR / BP 20 halaman. Stationary water heaters
Juga untuk Drazice OKC 200 NTRR / BP: Panduan Pengoperasian dan Pemasangan (17 halaman), Panduan Pengoperasian dan Pemasangan (12 halaman), Panduan Pengoperasian dan Pemasangan (19 halaman), Panduan Pengoperasian dan Pemasangan (20 halaman), Panduan Pengoperasian dan Pemasangan (18 halaman), Panduan Pengoperasian dan Instalasi (20 halaman), Panduan Pengoperasian dan Pemasangan (18 halaman), Panduan Pengoperasian dan Instalasi (13 halaman)

Halaman Cetak
Drazice OKC 200 NTRR / BP Panduan Pengoperasian dan Pemasangan

2.9 MOST FREQUENT FUNCTION FAILURES AND THEIR CAUSES

Potential failures – Table 6
FAILURE SYMPTOM
Water is cold
Water is not warm
enough
Temperature of water is
not corresponding
Water is constantly
dripping of the safety
valve
Table 6
Do not try to repair the failure yourselves. Seek either expert or service help. It does not take
much for an expert to remove the defect. When making a repair appointment, report the
type and serial number you find on the performance plate of your water heater.

3 OPERATION OF THERMOSTAT

3.1 OPERATING MODES

3.1.1 SERVICING

Service devices of heaters of 50 to 200 l capacity are located under the transparent guard of the control
panel. (Figure 7).
LED
•
is on
•
is not on
•
is on
•
is not on
SOLUTION
•
the temperature set on the
thermostat is too low
•
heating element silure
•
no supply voltage
•
termostat silure
•
safety termostat shut off
probably due to failed
operation termostat
•
failure of one of the coils in
the element (contains 2)
•
defective thermostat
•
input pressure too high
•
faulty safety valve
- 17 -