Dreadbox Nyx V2 Panduan Pemilik - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Synthesizer Dreadbox Nyx V2. Dreadbox Nyx V2 14 halaman. Analog, 2 oscillators, 12-24db dual filter, 2 function generators, extensive digital reverb, 30 eurorack patch points
Juga untuk Dreadbox Nyx V2: Manual Penyetelan (3 halaman)

Halaman Cetak
Dreadbox Nyx V2 Panduan Pemilik
The Patch Bay
The Nyx V2 has 30 patch points, offering endless routing and modulation possibilities.
The Patch Bay is consisted of 4 major parts:
GENERAL OUTPUTS
1. GATE : outputs the gate CV (0-6.5V pulse)
2. WHEEL : outputs the modulation wheel CV (0-5V)
3. MOD1 : outputs the Modulator 1 CV (0-5V)
4. MOD2 : outputs the Modulator 2 CV (0-5V)
5. CV : outputs the MIDI notes to CV (0-10V) over 10 octaves
6. LFO : Direct output of the LFO. When patching this, the effect on
the pitch of the oscillators will be cancelled. (+/- 3V)
7. OSC2 : outputs the selected wave of the OSC2 (+/- 5V)
8. MOD REV : outputs Reverb Modulation CV. Always at max level
(+/- 5V)
MIX
9-12. IN A, IN B, IN C, IN D : mixer inputs (+/- 10V max)
13. OUT: outputs the sum of IN A, IN B, IN C, IN D
LEVEL : sets the level of the mixer's output (+/- 10V max)
NOISE
14. OUT : white noise (+/- 5V max)
LEVEL : sets the level of the White Noise
INPUTS
15. CV1 : OSC1 CV input 1V/oct (+/- 2% off to precision) (+/-10V)
16. CV2 : OSC2 CV input 1V/oct (+/- 2% off to precision) (+/-10V)
17. CV : OSC1 and OSC2 CV input 1V/oct (+/- 2% off to precision) (+/-10V)
18. GATE : expects a 0 to 5V pulse so as to handle as a Gate signal. (can accept from 3.3V up to 10V)
19. PW : pulse width control over the square wave of OSC1
20. LEVEL : controls the amplitude of both OSC1 and OSC2 (+/-5V)
21. LEVEL1 : controls the amplitude of OSC1 (+/-5V)
22. LEVEL2 : controls the amplitude of OSC2 (+/-5V)
23. CUT A : controls the Cutoff frequency of Filter1 (+/-5V)
24. CUT B : controls the Cutoff frequency of Filter2 (+/-5V)
25. CUT : controls the Cutoff frequency of both Filter1 and Filter2 (+/-5V)
26. RES : controls the amount of the resonance (+/-5V)
27. FALL1 : controls the fall rate of the MOD1(+/-5V)
28. FALL2 : controls the fall rate of the MOD2(+/-5V)
29. VCF1 IN : audio input on VCF1
30. VCF2 IN : audio input on VCF2
10