Electrolux DFB09JFCWD Panduan Penggunaan dan Perawatan - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Penggunaan dan Perawatan untuk Mesin pencuci piring Electrolux DFB09JFCWD. Electrolux DFB09JFCWD 16 halaman. Freestanding dishwasher

Halaman Cetak

Water Softener/Salt

1) Remove the bottom rack of the dishwasher.

2) Unscrew and remove cap from the salt dispenser.

3) Place the end of the funnel (included with dishwasher)

into the hole and add about 1.5 kg. of dishwasher salt.

4) Fill the salt dispenser with water (It is normal for a

small amount of water to come out) .

5) After filling the container, screw the cap on tightly

in a counterclowise direction.

6) The salt indicator light will turn off once the salt

dispenser has been filled with salt.

7) Ensure that a short wash program is run after

the salt dispenser has been filled. Otherwise, the

filter system, pump or other important parts of the

machine may be damaged by salty water.

Note: The water softener/salt should only be

refilled when the salt indicator light on the control

panel turns on. Depending on how well the salt

dissolves, the salt warning light may still be on even

though the salt container is filled.

If there is not a salt indicator on the control panel

on the model of your dishwasher, you can estimate

when to refill the salt by the number of wash cycles

that the dishwasher has run.

Rinse Aid

Rinse aid greatly improves drying and reduces

water spots and filming. Water "sheets" off dishes

rather than forming water droplets that cling and leave

spots.

Filling Rinse Aid Dispenser:

1) A dispenser, located next to the detergent cup,

automatically releases a measured amount of rinse aid

during the last rinse. If spotting and poor drying are

problems, increase the amount of rinse aid dispensed by

removing the dispenser lid and rotating the dial to a higher

number. The dial is located under the dispenser cap.

The indicator will be completely dark when full and the

size of the dot on the indicator will diminish as the rinse

aid decreases.

DISHWASHER DISPENSERS

2) To add liquid rinse aid:

a)Turn dispenser cap to the open arrow (left) and lift out.

b)Pour in rinse aid until liquid touches the indicated fill level.

c)Replace cap by aligning it with the open arrow and turning

3) Do not overfill since this can cause oversudsing. Wipe up

any spills with a damp cloth.

Adjusting Rinse Aid Dispenser:

Depending on your dishwasher model, the rinse aid dispenser

has either four or six settings. Always start with the dispenser

set on "4". If spots and/or poor drying are a problem, increase

the amount of rinse aid released by removing the dispenser lid

and rotating the dial to "5". If the dishes are still not drying

properly or show spots, adjust the dial to the next higher level

until your dishes are spot free.

If there are sticky white stains on your dishes or a bluish film

on your glassware and knife blades, reduce the amount of

rinse aid released into your wash cycle.

Full

3/4 Full

1/4 Full

Should refill to eliminate spotting

Empty

it to the towards the closed arrow position (right).