Athletica Sport Systems FM-45G Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembeku Athletica Sport Systems FM-45G. Athletica Sport Systems FM-45G 8 halaman. Ice puck freezer

Ice Puck Freezer
Product User Manual
PARTS & FEATURES
Your portable freezer is supplied with all the
accessories you need to enjoy refrigeration almost
anywhere. Below is an image of the freezer features
and standard accessories.
Side
Handle
AC Power Cord
Insulated Lid
Latch
Wire Baskets
DC Power Cord
554 Parkside Drive, Waterloo, Ontario, Canada N2L 5Z4 TEL 519-747-1856
720 Innovation Drive, Shakopee, Minnesota, USA 55379 TEL 763-249-7465
Proper Location
Because this unit is compressor based appliance,
ample space is required around the unit to allow it to
exhaust
Position your portable freezer in a location where
there is proper air circulation and electrical
connections.
Keep the portable freezer away from heat and direct
sunlight if possible.
This portable freezer is suitable for vehicle use and
camping, however, the appliance should never be
exposed to rain.
This portable freezer should not be placed in a built-
in or recessed area. It is designed to be freestanding.
The normal operation of the freezer depends on
heat radiation from the condenser. For the initial
use, remove all packaging and allow at least 6" of
clearance around the perimeter of the freezer.
Movement & Installation
1. Remove all interior and exterior packaging.
2. Position the freezer in a dry and well-ventilated
place. Keep the freezer away from direct sunlight,
heaters and corrosive gases/chemicals.
3. Clean the interior surface with lukewarm water
and a soft cloth.
4. When inserting the AC power cord into the
power socket, make sure the power socket is
a grounded 115V~AC / 60Hz socket. Also, make
sure that the unit's grounding prong has not
being tampered with.
Note: When inserting the DC power-cord,
make sure the input is a 12V~DC / 24V power
source.
5. When moving the freezer, always use both
handles to the carry the unit as level as possible.
This is in order to protect the compressor and the
sealed system.