Carmanah E Series Panduan Pengguna - Halaman 15

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem Keamanan Carmanah E Series. Carmanah E Series 18 halaman. Rrfb mast arm kit
Juga untuk Carmanah E Series: Panduan Memulai Cepat (20 halaman), Instal Manual (16 halaman), Manual Penggantian Sistem Manajemen Energi (12 halaman), Instal Manual (20 halaman), Manual Penggantian (9 halaman), Instal Manual (18 halaman)

6.4

Adjusting Trigger Output Configuration

Under the "DR600 Setup", "Hardware & IO Config" tab are settings that control the system's activation behavior:

Output Hold Time: this setting controls how long the local (and any remote wirelessly-connected) Carmanah

E/F/G system(s) continue to flash after the radar module stops sensing vehicle motion. Default is 10 seconds. To

avoid erratic flashing, this setting should not be set below 5 seconds.

Trigger Event: this setting changes the conditions under which an activation of the connected Carmanah E/F/G

system is triggered:

None: no activations will occur.

•

Default: Displayed Target Above Speed Limit (default setting): Carmanah E/F/G system

•

activated when vehicle detected above configured Speed Limit on "Detection & Units" tab.

Displayed Target Below Speed Limit: Carmanah E/F/G system activated when vehicle

•

detected below configured Speed Limit on "Detection & Units" tab.

Any Displayed Target: Carmanah E/F/G system activated whenever a vehicle is detected,

•

regardless of speed.

Trigger Direction: this setting changes whether incoming vehicles, outgoing vehicles, or both will trigger the

connected Carmanah E/F/G system. Default setting is Incoming.

Click on "Save Changes" to save the changes to the radar module, or "Close" to disconnect from

the radar module without saving.

Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |

RADAR DETECTION KIT

carmanah.com