Aleo WPL2-80 Petunjuk Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Peralatan Pencahayaan Aleo WPL2-80. Aleo WPL2-80 2 halaman. Led wall pack

Halaman Cetak
This product SHALL be surface mounted with
to Install:
recessed junction box above 4 feet (1.2 meter) high.
User should prepare necessary accessories and
spare parts (not provided) including junction box,
cross bar, junction box gasket, wall fasteners and
anchors, silicone caulk.
1.
Surface Mount with Junction Box
Attach Mounting Plate (A) using appropriate hardware (supplied by others).
INSTALLER IS RESPONSIBLE FOR ENSURING PROPER FIXTURE
ATTACHMENT, INCLUDING SEALING TO THE JUNCTION BOX.
2.
Pull input lead wires through mounting plate hole
NOTE: pay special attention to NOT to damage insulation of wires.
3.
Wire AC main leads to fixture input leads. Make all electrical connections to
the fixture.
SEE PAGE 1 for Electrical Connection and wiring diagram instructions.
4.
Push wire connections back inside the Junction Box
5.
Angle fixture and slide onto mounting plate into the matching slots on the
back plate; situate fixture into place on the mounting plate
6.
Ensure no wires are being pinched by the fixture's metal parts
7.
Tighten the (2) set screws (C) located at the bottom of the fixture until fixture
is securely fastened
8.
Apply caulk or other sealant (supplied by others) to top and sides of fixture
where it meets the wall
Surface Mount with Conduit
1.
Loosen Screws (D) to open fixture from back plate
2.
Mount fixture back plate to the wall by fastening screws to back plate holes
(E)
3.
Remove Casting Plug Knockout from side of fixture where conduit will be
fed. Feed AC mains into knockout
4.
Wire AC main leads to fixture input leads. Make all electrical connections to
the fixture.
SEE PAGE 1 for Electrical Connection and wiring diagram instructions.
5.
Rotate fixture upwards (along hinge) to close fixture back
6.
Slide conduit tube through Casting Plug Knockeout and secure using
conduit nut. INSTALLER IS RESPONSIBLE FOR ENSURING PROPER
FIXTURE ATTACHMENT, INCLUDING SEALING TO THE JUNCTION BOX.
7.
Ensure no wires are being pinched by the fixture's metal parts
8.
Tighten the (4) screws (D) until fixture is securely fastened
9.
Apply caulk or other sealant (supplied by others) to top and sides of fixture
where it meets the wall
2 of 2
A: Mounting Plate
B: Junction Box
C: Set Screws (x2)
E: Mounting Plate Hole
WPL2
™
LED Wall Pack
A
C
1
5
B
E
3
Series
B
(FRONT)
(BACK)
WPL2-IS-0916