Anderson ANM77 Panduan Pengoperasian - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Pembakar Anderson ANM77. Anderson ANM77 14 halaman.

combustion chamber is purged. If it is ignited at a low temperature, it needs to be replaced

with 5 times the volume of the combustion chamber to avoid explosion.

However, it is not necessary to purge when the temperature is higher than 750℃. Air pipe

or gas pipe connected with burner should be tight enough with no leakage, also the

periodically check air or fuel nozzles of the burners to prevent to be blocked by dust, slag

or other materials.

ATTENTION: DANGER OF BEEN BURNT

When burner in operation, combustion is severe, so the burner must be fixed. Hoses or

cables in area of the combustion system must be suitable for high temperature, to prevent

high temperature failure or cause safety accidents. Burners should be periodically

inspected and cleaned. Copper wire brush may be used, if necessary, to clean burner head.

The burner system should be checked twice a year for safety operation.

Burner commissioning shall take care of ignition position, minimum and maximum output

position. Following interlocks will cause emergency stop, including gas low pressure, high

pressure or low combustion air pressure, as well as emergency stop is trigged, the main

power is out, UV signal failure or kiln safety conditions (such as high temperature limit, flue

system opening, etc.) will cause the burner lockout. Users need to know the maintenance

interval recommended by the manufacturer and the interval specified by national laws,

whichever is shorter.

4. Fuel Information

Following table shows combustion fuel characters of natural gas, safety rules must be

obeyed when operation carried out.

Fuel

Low Calorific value

Composition

Reference conditions

ANM77 series Burner is a patented product of Anderson Thermal Solutions (Suzhou) Co.,

Ltd. This series of linear burners adopts a modular structure design concept and can be

configured to match shapes according to site requirements.

It is an ideal choice for generating large amount of clean and hot air. Applications include

ovens, dryers, flue gas incinerators and similar industrial equipment, and are widely used

in heating industries such as gypsum board. This type of burner is designed based on the

Anderson Thermal Soluions（Suzhou）Co. Ltd.

Anderson Thermal Solutions – ANM77 Burner Operation Manual

Natural gas

35,900 [kJ/m

1,013.25 mbar, 0°C

]

>98% CH