Anderson FFO57 Panduan Pengoperasian - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Pembakar Anderson FFO57. Anderson FFO57 8 halaman.

Halaman Cetak

Burner dimension and inlet interface:

Burner Model

57G1000

57G1500

57G2000

5.2 Burner adjustment

On the non-combustion side, open the quick disassembly connector before installation and secure

the front sleeve part to the furnace wall. Position the burner retaining ring to the burner and firmly

with fastening screws. Then secure the burner and casing together using the quick removal

connector. Locch the burner to ensure the front of the burner does not extend the casing and

retreat for 1-5cm. Connect the burner main gas hose, main oxygen hose, ignition gas hose, ignition

oxygen hose, install the flame detector and wiring, connect the spark plug. Open all hand

regulating valves, adjust the cooling air flow, and check to ensure that all hoses are properly

connected.

6. Burner Maintenance

Burners require routine inspection. Examination after the first or long absence are particularly

important.

For the first use, check that the seal of each interface is intact and not loose. After the burner is first

used normally, the burner needs to be checked. In the first month, the burner, the spark plugs, the

flame detectors are checked on the week, and the inspection frequency can be extended to once two

weeks in the second month. Anderson suggested that the burner check out at least once a month.

Each inspection requires the inspection when the system is down and has cooled to room

temperature.

7. Spare Parts

For normal use and regular maintenance of the burner, we recommend preparing the following parts:

– Flame Detector

– Spark Rod

– Burner Spare Sleeve

Anderson Thermal Soluions（Suzhou）Co., Ltd

Input kW

A(mm)

B(mm)

1MW

1000

1.5MW

895

2MW

805

Anderson Thermal Solutions – FFO57 Operation Manual

C(mm)

D(mm)

1323

DN50

1215

DN50

1267

DN50

E(mm)

DN32

DN40