Anderson PBO92 Panduan Pengoperasian - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Pembakar Anderson PBO92. Anderson PBO92 8 halaman.

1. When the burner is stopped, only the gas supply shall be

cut off, and the combustion auxiliary air should not be cut off

immediately. If the combustion auxiliary air is interrupted for

more than 5 minutes, the burner should be removed to

prevent damage to the burner and the flame detector.

2. When the gas is not completely closed, do not remove the

gas metal hose or the locking device

5.1 Burner Data

Burner

Input

Type

92G50

10-30

Fix the burner on position, ensure that the burner does not slide by external forces. Connect the

burner oxygen hose to the combustion oxygen inlet. Connect the burner gas hose to the gas inlet.

Open the combustion oxygen valve and test the pressure at 1-15 mbar, which should be properly

adjusted according to the kiln pressure. Check and confirm that both the oxygen hose and the

gas hose are correctly and firmly connected. Open the gas valve and adjust the gas flow regulating

valve to ensure flame stability.

Burners require routine inspection. Examination after first or long absence are particularly important.

For the first use, check that the seal of each interface is intact and not loose. After the burner is first

used normally, the burner needs to be checked. The pilot burner is checked weekly in the first month,

and at the second month, the inspection frequency can be extended to once in two weeks. Anderson

Anderson Thermal Soluions（Suzhou）Co., Ltd

igure 1: PBO92 Series air burner

Burner

Length

(mm)

300-950

Anderson Thermal Solutions – PBO92 Operation Manual

Attention!

Gas Flow

Gas Pressure

(Nm

/h)

Min

Max

Min

Oxygen

Pressure

(mbar)

Max

Min

Max