Airtec CYPRES Buku Petunjuk - Halaman 4

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Ukur Airtec CYPRES. Airtec CYPRES 17 halaman. Water resistant kit

First:

Right now every CYPRES that should be made water resistant has to see

Airtec or SSK.

There a generell check for all important properties is done and

• the control unit and

• the plug in the cutter cable and

• the lower part of the cutter and

• if existing a splice in the control unit cable

are sealed.

Looking at these items you will realise something like a transparent plastic

coating.

Please check the sealings when you easily have access.

Second:

• Only a CYPRES with undamaged cables can be made water resistant. Holes

or slits in cables will allow water to find a route through the inside of the

cables into the processing unit.

• After the assembly and testing of the water resistant housing, the silicone

needs 12 hours time to cure completely. Do not install the housing in a rig

before this time.

• The main processing unit pouch in the reserve container has to be changed

to the larger pouch. Please install the new (OD green) pouch according to

the instructions in the CYPRES Riggers Guide, page 9.

• As mentioned before, the mounting of the water resistant housing requires

concentrated work, which has to be done without any errors.

• Once installed, the water resistant version needs more maintenance and

care. Additionally, the volume of the AAD increases.

Because of the above reasons we strongly recommend installing a water

resistant CYPRES only when it is really needed and not "because it may be

better".

Thank you for your understanding.

Instruction Manual CYPRES Water Resistant Kit

Important Information

Airtec GmbH

page 4