Compac ComTank Lembar Instalasi - Halaman 9

Jelajahi secara online atau unduh pdf Lembar Instalasi untuk Dispenser Compac ComTank. Compac ComTank 18 halaman.

Mounting Preparation

Compac Industries Ltd.

The ComTank unit needs to be mounted to a flat, steel plate prepared with a cut-out

and fastener holes as per drawing below. A steel template marked with the

appropriate dimensions is available as an option from Compac. Holes are drilled to

clear M6 (6 mm diameter) studs.

Ensure your mounting plate is thin enough to allow you to put the washers and nuts

on the end of the 20mm long studs.

The plate the ComTank is mounted on should be rust protected if it is not made from

stainless steel.

Ensure there is sufficient access to allow the installer and service people to

comfortably remove the cover from the rear of the unit and perform service work. A

minimum clearance of 850 mm is recommended.

Figure 1 ComTank Panel Cutout. Note: Do not cut to outer lines.

If installing ComTank pumps as part of the installation, refer to the ComTank Pump

Installation Sheet for pump, display and nozzle holder mounting instructions.

Page 9