Compac FP50 G3 Buku Petunjuk - Halaman 2

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Listrik Compac FP50 G3. Compac FP50 G3 13 halaman. Presses datelier

Halaman Cetak

Instruction Manual

Press with air operated fast approach and air return piston.
Model:
HP/FP40 G2, HP/FP50 G3, HP60 G2, HP70 G2
Important: Read and understand this manual before use.
Warning!
If the instructions below are not followed, it can cause serious personal injury.
Instruction:
Make sure that you and your colleagues are aware of the product and its possibilities. All users must for
their own safety and the safety of others follow the operating/safety instructions. Always keep this manual
intact and stored nearby the product.
Transportation:
1. Using a forklift: The forks are placed under the top frame, the lifting points are marked on the
transport packaging.
2. Using a crane: Only use straps with a capacity high enough to lift the weight of the press.
Note: The straps must only be mounted at the top of the press and must be protected
from sharp edges .
3. Using a lifting trolley: The press must be supported so it cannot tip over.
Safety:
Do not use the press beyond its intended purpose.
When using the press be aware of the risk of ejection of work pieces.
Preparation:
1. An authorized/skilled operator must visually check the press for
leaks and damages, this inspection must be made at least one
time annually.
2. Install the pressure gauge. (Pressure gauge is not mounted on
the press, to avoid damage during transport).
Do not use packing tape or equivalent.
Tighten the presser gauge with a 22 mm wrench while holding a
27 mm wrench counter to tighten the base of the pressure gauge
towards a cutting ring. In case the pressure gauge isn't turned
into the right position it can be rotated by loosening the bottom
nut with a 24 mm wrench while holding a 27 mm wrench coun-
ter, Turn the manometer so it's facing the right way and tighten
the lower nut again.
HP-FP-40 G2-50 G3-60 G2-70 G2 (GB) V 1.1
1/3
13-08-2015 SN/PD