Compac FP50 G3 Інструкція з експлуатації - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент Compac FP50 G3. Compac FP50 G3 13 сторінок. Presses datelier

Instruction Manual

Press with air operated fast approach and air return piston.

Model:

HP/FP40 G2, HP/FP50 G3, HP60 G2, HP70 G2

Important: Read and understand this manual before use.

Warning!

If the instructions below are not followed, it can cause serious personal injury.

Instruction:

Make sure that you and your colleagues are aware of the product and its possibilities. All users must for

their own safety and the safety of others follow the operating/safety instructions. Always keep this manual

intact and stored nearby the product.

Transportation:

1. Using a forklift: The forks are placed under the top frame, the lifting points are marked on the

transport packaging.

2. Using a crane: Only use straps with a capacity high enough to lift the weight of the press.

Note: The straps must only be mounted at the top of the press and must be protected

from sharp edges .

3. Using a lifting trolley: The press must be supported so it cannot tip over.

Safety:

Do not use the press beyond its intended purpose.

When using the press be aware of the risk of ejection of work pieces.

Preparation:

1. An authorized/skilled operator must visually check the press for

leaks and damages, this inspection must be made at least one

time annually.

2. Install the pressure gauge. (Pressure gauge is not mounted on

the press, to avoid damage during transport).

Do not use packing tape or equivalent.

Tighten the presser gauge with a 22 mm wrench while holding a

27 mm wrench counter to tighten the base of the pressure gauge

towards a cutting ring. In case the pressure gauge isn't turned

into the right position it can be rotated by loosening the bottom

nut with a 24 mm wrench while holding a 27 mm wrench coun-

ter, Turn the manometer so it's facing the right way and tighten

the lower nut again.

HP-FP-40 G2-50 G3-60 G2-70 G2 (GB) V 1.1

1/3

13-08-2015 SN/PD