Electrolux DI 8610 Panduan Pengoperasian dan Instalasi - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Pengoperasian dan Instalasi untuk Kap Ventilasi Electrolux DI 8610. Electrolux DI 8610 24 halaman. Cooker hood
Juga untuk Electrolux DI 8610: Petunjuk Pengoperasian dan Pemasangan (20 halaman)
Control device for grease and charcoal filters
This hood is fitted with a device that signals when it is necessary to
clean the grease filter or the charcoal filter (in the case of recirculation
version with charcoal filter).
On delivery, the hood is not supplied with an charcoal filter, so the
saturation indicator will be disabled.
If the hood is to be used with a charcoal filter, the saturation
indicator light must be enabled as follows:
Press buttons B and G simultaneously and hold them for 3 seconds.
At first only the grease filter LED D will light up, but when the charcoal
filter LED E lights up the saturation indicator will be enabled.
To disable it: Press buttons B and G again simultaneously and hold
them for 3 seconds, until the charcoal filter LED goes out.
Grease filter LED (D)
LED D will start to flash when it is time to clean the grease filter.
Cleaning will be necessary after 40 working hours. Always comply with
the maintenance instructions for the grease filter (see page 9).
Charcoal filter LED (E)
The charcoal filter LED E will start to flash when the charcoal filter
needs to be replaced.
This operation is necessary after approximately 160 working hours.
(Please see page 10 for instructions on Cleaning/replacing).
Resetting the saturation indicator
After cleaning or replacing the filters, press button A for 3 seconds
until the grease filter LED D or the charcoal filter LED E stops flashing.
8