- ページ 8

換気フード Electrolux DI 8610のPDF 操作および設置マニュアルをオンラインで閲覧またはダウンロードできます。Electrolux DI 8610 24 ページ。 Cooker hood
Electrolux DI 8610 にも：操作およびインストール手順 (20 ページ)

Control device for grease and charcoal filters

This hood is fitted with a device that signals when it is necessary to

clean the grease filter or the charcoal filter (in the case of recirculation

version with charcoal filter).

On delivery, the hood is not supplied with an charcoal filter, so the

saturation indicator will be disabled.

If the hood is to be used with a charcoal filter, the saturation

indicator light must be enabled as follows:

Press buttons B and G simultaneously and hold them for 3 seconds.

At first only the grease filter LED D will light up, but when the charcoal

filter LED E lights up the saturation indicator will be enabled.

To disable it: Press buttons B and G again simultaneously and hold

them for 3 seconds, until the charcoal filter LED goes out.

Grease filter LED (D)

LED D will start to flash when it is time to clean the grease filter.

Cleaning will be necessary after 40 working hours. Always comply with

the maintenance instructions for the grease filter (see page 9).

Charcoal filter LED (E)

The charcoal filter LED E will start to flash when the charcoal filter

needs to be replaced.

This operation is necessary after approximately 160 working hours.

(Please see page 10 for instructions on Cleaning/replacing).

After cleaning or replacing the filters, press button A for 3 seconds

until the grease filter LED D or the charcoal filter LED E stops flashing.