Electrolux EFC 6940 Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kap Ventilasi Electrolux EFC 6940. Electrolux EFC 6940 13 halaman. Electrolux cooker hood
Juga untuk Electrolux EFC 6940: Panduan Pengguna (16 halaman), Panduan Pengguna (16 halaman), Panduan Pengguna (16 halaman)

Halaman Cetak

Installation

Mounting accessories included

1 deflector

1 chimney support

1 reduction flange Ø 125-120 mm

1 support bracket

5 wood-screws 5 x 45 mm

5 wall plugs Ø 8 mm

8 metal screws 2,9 x 6,5

4 metal screws 4 x 20

Wall unit mounting - Fig. 8

First decide which functioning version is better for

you.

If you decide to use the hood in exhausting version

we suggest to position the upper section of the

chimney so that the oulet slots are not visible once

installation has ended, on the contrary if is decided

to use the hood in recycling version BE SURE that

the side with slots is up (see also A-B-C sequence

on on Fig. 8).

• Sign the wall with a center line, this will aid

mounting procedure (1), position the template so

that the mid line printed on the template

matches with the center line previously signed,

the lower side of the template corresponds to

the lower side of the hood once mounted (2).

• Drill two holes Ø 8mm and fix the support

bracket with two wall plugs and screws (3).

• Hang the hood (4) adjust its position (5-6) and

from the inside of the hood sign one point for

definitive fixing (7), remove the hood and drill

an hole Ø 8mm (8), fit a wall plugs, hang the

hood again and fix it definitively with a screw

(9).

• Drill two holes Ø 8mm on the upper side close

to the ceilling (10), fit two wall plugs and fix the

chimney support with two screws (11).

In case the hood is to be used in filter version,

mount the deflector F on the chimney support

with four screws 2,9x6,5 and fit an exhausting

pipe (12) to connect deflector to the outlet hole

D of the hood.

In case the hood is to be used in exhausting

version, then the deflector must not be mounted

and fit an exhausting pipe (12) to connect outlet

hole D of the hood to the outside.

• Make electrical connection (13), but leave the

hood disconnected from the home general

electric panel.

• Insert the vapour screen on the motor housing

and fix it with four screws M4x20 (14).

• Fix the chimney first up (15a) to the chimney

support (15b), then on the bottom (16a) to the

upper side of the frame (16b) using four screws

2,9x6,5.

• Connect the hood the the home general electric

panel and check if the hood work properly.