Electrolux EFC 6940 Manual do utilizador - Página 9
Procurar online ou descarregar pdf Manual do utilizador para Campânula de ventilação Electrolux EFC 6940. Electrolux EFC 6940 13 páginas. Electrolux cooker hood
Também para Electrolux EFC 6940: Manual do utilizador (16 páginas), Manual do utilizador (16 páginas), Manual do utilizador (16 páginas)
Imprimir página
Installation
Mounting accessories included
1 deflector
1 chimney support
1 reduction flange Ø 125-120 mm
1 support bracket
5 wood-screws 5 x 45 mm
5 wall plugs Ø 8 mm
8 metal screws 2,9 x 6,5
4 metal screws 4 x 20
Wall unit mounting - Fig. 8
First decide which functioning version is better for
you.
If you decide to use the hood in exhausting version
we suggest to position the upper section of the
chimney so that the oulet slots are not visible once
installation has ended, on the contrary if is decided
to use the hood in recycling version BE SURE that
the side with slots is up (see also A-B-C sequence
on on Fig. 8).
• Sign the wall with a center line, this will aid
mounting procedure (1), position the template so
that the mid line printed on the template
matches with the center line previously signed,
the lower side of the template corresponds to
the lower side of the hood once mounted (2).
• Drill two holes Ø 8mm and fix the support
bracket with two wall plugs and screws (3).
• Hang the hood (4) adjust its position (5-6) and
from the inside of the hood sign one point for
definitive fixing (7), remove the hood and drill
an hole Ø 8mm (8), fit a wall plugs, hang the
hood again and fix it definitively with a screw
(9).
• Drill two holes Ø 8mm on the upper side close
to the ceilling (10), fit two wall plugs and fix the
chimney support with two screws (11).
In case the hood is to be used in filter version,
mount the deflector F on the chimney support
with four screws 2,9x6,5 and fit an exhausting
pipe (12) to connect deflector to the outlet hole
D of the hood.
In case the hood is to be used in exhausting
version, then the deflector must not be mounted
and fit an exhausting pipe (12) to connect outlet
hole D of the hood to the outside.
• Make electrical connection (13), but leave the
hood disconnected from the home general
electric panel.
• Insert the vapour screen on the motor housing
and fix it with four screws M4x20 (14).
• Fix the chimney first up (15a) to the chimney
support (15b), then on the bottom (16a) to the
upper side of the frame (16b) using four screws
2,9x6,5.
• Connect the hood the the home general electric
panel and check if the hood work properly.
36