Atlas Copco SMC-100-1600 Petunjuk Produk - Halaman 6
Jelajahi secara online atau unduh pdf Petunjuk Produk untuk Peralatan Atlas Copco SMC-100-1600. Atlas Copco SMC-100-1600 16 halaman. Torque arm
Installation
Installation
Installation instructions
Installing the torque arm
The tool torque should not exceed the specified torque range of each spe-
cific arm.
Do not use SMC 200 and SMC 300 with a bench stand.
Mounting on a bench
• Find the optimal position for the operator to handle the torque arm.
• Install the torque arm straight in front of the operator or alternatively to the
left or right depending on whether the operator is left or right-handed.
• Firmly tighten the screws in the holder that connects the torque arm to the
bench stand. The bench stand is pre-drilled for fixing to a bench.
• Attach the safety wire (see Spare Parts) to a second point that does not limit
the working area.
Mounting on a ceiling
• Put the mounting point straight above, or as close as possible to, the point
where the torque is applied.
• Make sure that the fixation point can handle the weight and the torque of the
chosen torque arm.
• Attach the safety wire (see Spare Parts) to a second point that does not limit
the working area.
6
EN
© Atlas Copco Industrial Technique AB - 9836 8267 01
SMC-100-1600