Atlas Copco SMC-100-1600 Petunjuk Produk - Halaman 7

Jelajahi secara online atau unduh pdf Petunjuk Produk untuk Peralatan Atlas Copco SMC-100-1600. Atlas Copco SMC-100-1600 16 halaman. Torque arm

Atlas Copco SMC-100-1600 Petunjuk Produk
SMC-100-1600

Attaching and balancing the tool when mounted on a bench

Do not use SMC 200 and SMC 300 with a bench stand.
1. Adjust the height of the arm relative to the work piece. It is recommended
to mount the arm attachment at the same height as where the torque is ap-
plied.
2. Attach the tool holder to the tool.
3. Attach the tool holder to the arm. Install the screw and tighten it:
• SMC 12/25 (M6) - 10 Nm
• SMC 50/100 (M8) - 24 Nm
4. Install the set screw on the tool holder and tighten it to 2.5 Nm.
5. Balance the tool with the balancer.

Working area when mounted on a bench

EN
© Atlas Copco Industrial Technique AB - 9836 8267 01
Installation
7