Advanced Radiant Systems Cool-Space CSW-12-VD Panduan Pemilik - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pembersih Udara Advanced Radiant Systems Cool-Space CSW-12-VD. Advanced Radiant Systems Cool-Space CSW-12-VD 19 halaman.

Halaman Cetak

One of the few inconvenient aspects of evaporative cooling is the control of unpleasant odors.

There are two primary causes of these odors:

1. Initial wetting of new pads

2. Poor maintenance and storage behaviors and/or poor quality water.

Your EVAP-series cooler has been delivered with pads that have never been wet. The same is

true of replacement pads. The resins and adhesives used to create these pads will give off an

odor during initial use that can last for a week or more. This can't be avoided but it can be

minimized. As the cooler is used over time, algae and bacteria growth can occur. This can also

be minimized. Below are recommended actions to be taken to address noticeable odor due to

the above causes.

Odor from Initial Wetting of Pads

1. At first use of your new cooler or after

installing new replacement pads, make

certain there is lots of fresh air available

to the cooler.

2. Add one capful of liquid laundry fabric

softener to the water in the bottom

reservoir of the cooler.

3. The odor from initial wetting of pads

should disappear in approx. two weeks

of operation.

4. If odor does not disappear after two

weeks of operation, follow the steps for

"Periodic Odor Maintenance".

Page 10 of 16

ODOR CONTROL

1. Make certain the cooler is full of fresh

2. Flush the pads for 3 – 4 hours by

3. After flushing, empty the reservoir

4. Refill reservoir with fresh water and

5. Repeat the above steps as necessary

Periodic Odor Maintenance

water.

operating the pump only with the fan

off. Adjust flow control valve for

maximum rate of recirculating water

flow.

through the front drain and clean out

any residual particulate in the

reservoir.

proceed to use the cooler.

to eliminate odor.