Advanced Radiant Systems Cool-Space CSW-12-VD Instrukcja obsługi - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Oczyszczacz powietrza Advanced Radiant Systems Cool-Space CSW-12-VD. Advanced Radiant Systems Cool-Space CSW-12-VD 19 stron.
Drukuj stronęOne of the few inconvenient aspects of evaporative cooling is the control of unpleasant odors.
There are two primary causes of these odors:
1. Initial wetting of new pads
2. Poor maintenance and storage behaviors and/or poor quality water.
Your EVAP-series cooler has been delivered with pads that have never been wet. The same is
true of replacement pads. The resins and adhesives used to create these pads will give off an
odor during initial use that can last for a week or more. This can't be avoided but it can be
minimized. As the cooler is used over time, algae and bacteria growth can occur. This can also
be minimized. Below are recommended actions to be taken to address noticeable odor due to
the above causes.
Odor from Initial Wetting of Pads
1. At first use of your new cooler or after
installing new replacement pads, make
certain there is lots of fresh air available
to the cooler.
2. Add one capful of liquid laundry fabric
softener to the water in the bottom
reservoir of the cooler.
3. The odor from initial wetting of pads
should disappear in approx. two weeks
of operation.
4. If odor does not disappear after two
weeks of operation, follow the steps for
"Periodic Odor Maintenance".
Page 10 of 16
ODOR CONTROL
1. Make certain the cooler is full of fresh
2. Flush the pads for 3 – 4 hours by
3. After flushing, empty the reservoir
4. Refill reservoir with fresh water and
5. Repeat the above steps as necessary
Periodic Odor Maintenance
water.
operating the pump only with the fan
off. Adjust flow control valve for
maximum rate of recirculating water
flow.
through the front drain and clean out
any residual particulate in the
reservoir.
proceed to use the cooler.
to eliminate odor.