Bose Lifestyle 35 Series II Panduan Instalasi - Halaman 31

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Sistem Teater Rumah Bose Lifestyle 35 Series II. Bose Lifestyle 35 Series II 36 halaman. Noise cancelling
Juga untuk Bose Lifestyle 35 Series II: Panduan Instalasi (42 halaman), Panduan Pemilik (25 halaman), Panduan Pemilik (24 halaman), Panduan Pemilik (13 halaman), Panduan Pengaturan Cepat (3 halaman), Panduan Pengoperasian (46 halaman), Panduan Pemilik (36 halaman), Panduan Pemilik (32 halaman), Panduan Memulai Cepat (2 halaman), Reset Pabrik (2 halaman), Panduan Memulai Cepat (2 halaman), Panduan Pemilik (38 halaman)

Other jacks on the media center panel

If your remote control does not communicate with the media center, the batteries may need

replacement or it may be out of transmission range. To extend the range, plug an antenna

extender, which may be purchased at an authorized Bose

media center. See Figure 27 on page 30.

The IR (infrared) emitter cable is designed for optional use when a particular component does

not respond to LIFESTYLE

connected to the media center, but placed where it cannot receive the IR signals from the

media center. The IR emitter can be placed next to one component only. See Figure 27 on

page 30.

To use the emitter:

1. Insert the 3.5 mm plug into the IR EMITTER jack on the media center panel.

2. Place the flat side of the other end of the cable near the unresponsive component so that

the remote control signals reach that component.

Note: Refer to "Controlling external sources" in your LIFESTYLE

details on how to program the LIFESTYLE

component.

3. Confirm that IR signals now work to control that component. Move the emitter around, as

necessary, to find the best position.

4. Use the double-sided tape enclosed with the emitter to affix it in the proper position.

Note: If you have questions, or need to obtain a replacement emitter, contact Bose customer

service. Refer to the Bose address list included with your system.

Some systems will have a data port for future use. See Figure 27.

This jack is for factory and service use only.

system remote control commands. That is, the component is

system remote so that it works with your other

Reference

dealer, into its connection on the

system Operating Guide for