Advanced Radio Smart Switch Panduan Memulai Cepat - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Panel Kontrol Advanced Radio Smart Switch. Advanced Radio Smart Switch 15 halaman.

Mounting the Smart Display

There are 2 options of mounting the Smart display.

NOTE: Which ever method of mounting you choose, ensure the purple cable that comes

out of the Smart Display is not crushed in anyway. Doing so will reduce the longevity of

the cables.

Option 1. Using the remaining pieces of 3M clear tape, we can mount the back of the screen

to a surface.

tion. AVOID MOUNTING IN HIGH VIBRATION AREAS. VIBRATION DAMAGE IS NOT COV-

ERED UNDER WARRANTY.

surface that it is being mounted. Place a piece of 3M tape each side of the purple cable.

Trimming the tape as necessary. Remove the clear film and place the tape on the back of the

screen then press the screen into place.

THE SCREEN WITH FORCE AS IT MAY BREAK.

ensure it is secure

Option 2. For hard mounting, the screen case has 2 little tabs with eyelet holes in them. If you are

mounting the screen in a scale cockpit, or in a non vibration model. (e.g Turbine) these holes can be

used to affix the Smart Display.

Simply place the Smart Display where you wish to mount it. Holding it in place, make a dot using a

pen or pencil in each eyelet hole. Removing the screen, drill a hole where you placed the dots.

Now simply screw the Smart Display in place.

NOTE: Hard mounting the Smart Display provides little to no protection against vibration.

Use this method if you are using a non vibration model or only where there is little to no

vibration. AVOID MOUNTING IN HIGH VIBRATION AREAS. VIBRATION DAMAGE IS NOT

COVERED UNDER WARRANTY.

NOTE: This is a semi hard mount, and will provide a good resistance to vibra-

As mentioned above, clean both the back of the smart screen and

IMPORTANT: DO NOT APPLY FORCE DIRECTLY ON TO

Press on the black case around the screen to