Bose M277296_01_PAS_UKEvo Panduan Pemilik - Halaman 12
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penguat Bose M277296_01_PAS_UKEvo. Bose M277296_01_PAS_UKEvo 28 halaman.
![Bose M277296_01_PAS_UKEvo Panduan Pemilik](/uploads/products/server2/1496244/1496244.jpg)
Connecting a B1 bass module to the PS1 power stand (optional)
Figure 5
Bass module orientations
Figure 6
B1 bass module
The
two B1 bass modules. B1 bass modules can be placed on the floor vertically or horizontally.
Up to four modules can be stacked when placed horizontally (Figure 1).
CAUTION: Do not connect more than two B1 bass modules to the B1 Bass Module (Amp 3
OUT) jack on the PS1 power stand. Driving more than two B1 bass modules from the B1 Bass
Module (Amp 3 OUT) output will improperly load the amplifier in the PS1 power stand, resulting
in less than full system performance.
CAUTION: Only B1 bass modules should be used in the B1 Bass Module (Amp 3 OUT) jack.
B1 bass modules can
be placed vertically or
horizontally
Connecting one B1 bass module
Insert one end of the B1 bass module 4-wire cable into one of the jacks on the rear panel
of the B1 bass module. Insert the other end of the 4-wire cable into the
jack on the PS1 power stand connector panel.
To connect, push the plug
into the jack and rotate it
clockwise to lock it.
To disconnect, slide back the metal tab on the
body of the plug, rotate the plug counterclockwise
and pull it out of the jack.
Note: The B1 bass module connector will click softly upon being properly engaged.
CAUTION: A B1 bass module cannot be shared between two PS1 power stands.
jack on the PS1 power stand can adequately drive one or
B1 bass modules can
be stacked in a column
of up to four, maximum
To
B1 Bass Module
(Amp 3 OUT)
B1 bass module 4-wire cable (blue)
Setup
12