Bose M277296_01_PAS_UKEvo Manuale d'uso - Pagina 12

Sfoglia online o scarica il pdf Manuale d'uso per Amplificatore Bose M277296_01_PAS_UKEvo. Bose M277296_01_PAS_UKEvo 28.

Connecting a B1 bass module to the PS1 power stand (optional)

Figure 5

Bass module orientations

Figure 6

B1 bass module

The

two B1 bass modules. B1 bass modules can be placed on the floor vertically or horizontally.

Up to four modules can be stacked when placed horizontally (Figure 1).

CAUTION: Do not connect more than two B1 bass modules to the B1 Bass Module (Amp 3

OUT) jack on the PS1 power stand. Driving more than two B1 bass modules from the B1 Bass

Module (Amp 3 OUT) output will improperly load the amplifier in the PS1 power stand, resulting

in less than full system performance.

CAUTION: Only B1 bass modules should be used in the B1 Bass Module (Amp 3 OUT) jack.

B1 bass modules can

be placed vertically or

horizontally

Insert one end of the B1 bass module 4-wire cable into one of the jacks on the rear panel

of the B1 bass module. Insert the other end of the 4-wire cable into the

jack on the PS1 power stand connector panel.

To connect, push the plug

into the jack and rotate it

clockwise to lock it.

To disconnect, slide back the metal tab on the

body of the plug, rotate the plug counterclockwise

and pull it out of the jack.

Note: The B1 bass module connector will click softly upon being properly engaged.

CAUTION: A B1 bass module cannot be shared between two PS1 power stands.

jack on the PS1 power stand can adequately drive one or

B1 bass modules can

be stacked in a column

of up to four, maximum

B1 Bass Module

(Amp 3 OUT)

B1 bass module 4-wire cable (blue)

Setup