ANLIDAR MYTORQ MY-SAVER Panduan Pengguna - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Alat Ukur ANLIDAR MYTORQ MY-SAVER. ANLIDAR MYTORQ MY-SAVER 16 halaman.
Halaman Cetak
4. Control setting
Name
OPERTION MODE
DEVICE ID
TOOL START
METHOD
SETTING
TOOL LED
SETTING
EDIT JOB
SEQENCE
SETTING
PROGRAM
DEFAULT
TORQUE UNIT
GATE MODE
OKALL SIGNAL
STORE JOB
BARCODE
Set Up Time
and Value
STD/ADV
Connection mode.
STD: Standalone mode.
ADV: KL-AMS network system.
(STD/ADV) connection mode.
001~250
Equipment No.
Both/Push
Choose tool start mode.
/Lever
Start on/Always
Set tool LED on or off.
on/Off
Setup screw sequence and repeat. time in job
Job：01~50
project, save up to 50 projects.
JS：01~50
JS: display job sequence.
TP：00~99
TP: display tightening program.
TR：00~99
TR: display repeat times.
Remove the screw button settings:
Reverse button
Forward (CW) and reverse (CCE) can be set
setting：
1. Direction:
Force Level：Number of force segments
CW/CCW
Force0(disable)、1~9(10%~100%)
2. Force
Level:0~9
RPM：set to remove the screw speed
3. RPM：
Please refer to the
specification of
screwdrivers
00~50
Select program
N/Y
Return to default status and remove all
memory data.
Kgf.cm/N.m
Set up torque display unit.
/kgf.m
/lbf.in
None/Once/Twice None: Function off.
Once: Workpiece in position (Short signal.)
Twice: Workpiece in/out position (Open
signal).
Once/Each
OKALL signal output method
Once: Output OKALL signal after all
sequences completed. OKALL signal output
time depends on At setting.
Each: Output OKALL signal after each
sequence completed. OKALL signal output
time depends on At setting.
1~50
"Scan job barcode "will show after pressing.
After using scanner to scan barcode, it will
save barcode into controller automatically.
Setup sequence 1 to 50, it will switch to
barcode sequence. Barcode length should not
exceed 54 bits.
Function Description
6
Default
setting
STD
01
Both
Off
Job：01
JS：01
TP：00
TR：00
00
N
Kgf.cm
OFF
Once
01