Becom Argos3D-Pulse Panduan Memulai Cepat - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Aksesori Becom Argos3D-Pulse. Becom Argos3D-Pulse 11 halaman.

Quick Start Guide - Argos3D-Pulse

Last change: 1 October 2021/Version 2

Note

Please follow the next steps in the right order to get your 'Argos3D-Pulse' up and running

correctly.

1.3.1

Connecting the break-out board

Please connect the break-out board to the Argos3D-Pulse common connector first.

1.3.2

To ensure, that your Argos3D-Pulse works correctly, connect the 'Argos3D' to a 12-30V DC power supply using

connector (a) and wait for approximately 20 seconds until the camera boots up.

Pin assignment on the power connector (a): Pin #1: +12V to +30V, Pin#2: GND

Note

The power supply connector is protected against wrong polarity but the 'Argos3D' will not

work in case you don't use the correct polarity! If the Argos3D-Pulse doesn't work please

check the power supply polarity first!

Argos3D-Pulse

Figure 1-2:

common connector

6 | 11