Anolis ArcSource Submersible II Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Pencahayaan Anolis ArcSource Submersible II. Anolis ArcSource Submersible II 6 halaman.

Halaman Cetak

1. Introduction

The ArcSource Submersible II has a housing crafted from the highest quality marine grade bronze meaning its
is capable to withstand the very harshest environmental conditions. The ArcSource Submersible II can easily
operate constantly submersed up to 10 m and offers more than 10 different beam options for positioning free-
dom.

2. Safety information

The unit must be installed by a qualified electrician in accordance with all national
and local electrical and construction codes and regulations.
The persons who are in charge of installation should have the required qualifications for this
type of work
Avoid using the unit in locations subject to possible impacts.
The unit is intended only for permanent underwater installation up to depth of 10 m.
The relevant provisions of UL 676 Underwater Luminaires and Submersible Junction Boxes
must be observed for installation.
Do not let the unit in frozen water.
All service works have to be done in a dry environment (e.g. in a workshop).
Avoid looking directly into the LED light beam at close range.
Immunity of the equipment is designed for electromagnetic environments E1, E2, E3 according to
the standard EN55103-2 ed.2 Electromagnetic compatibility. Product family standard for audio, video,
audiovisual and entertainment lighting control apparatus for professional use. Part 2: Immunity.
The product (covers and cables) must not be exposed to a high frequency electromagnetic field higher
than 3V/m.
The installation company should check levels of possible interferences above the tested levels E1,E2,E3 given
by this standard (e.g. transmitters in surrounding area) before installing the equipment.
Emission of the equipment complies with the standard EN55032 Electromagnetic compatibility of multimedia
equipment – Emission Requirements according to class B.

3. Mounting

The ArcSource Submersible II can be arranged in any position orientation. The LED module body is mounted
on a bronze bracket for tilt adjustment . Use the Allen key no.6 to adjust desired tilt position of the LED module
by means of two tilt locks (1). For fastening the ArcSource Submersible II to the flat surface use either three
holes or two semicircle slots which allows fine adjusting the fixture in a pan direction.
3