- ページ 3

照明器具 Anolis ArcSource Submersible IIのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Anolis ArcSource Submersible II 6 ページ。

1. Introduction

The ArcSource Submersible II has a housing crafted from the highest quality marine grade bronze meaning its

is capable to withstand the very harshest environmental conditions. The ArcSource Submersible II can easily

operate constantly submersed up to 10 m and offers more than 10 different beam options for positioning free-

dom.

The unit must be installed by a qualified electrician in accordance with all national

and local electrical and construction codes and regulations.

The persons who are in charge of installation should have the required qualifications for this

type of work

Avoid using the unit in locations subject to possible impacts.

The unit is intended only for permanent underwater installation up to depth of 10 m.

The relevant provisions of UL 676 Underwater Luminaires and Submersible Junction Boxes

must be observed for installation.

Do not let the unit in frozen water.

All service works have to be done in a dry environment (e.g. in a workshop).

Avoid looking directly into the LED light beam at close range.

Immunity of the equipment is designed for electromagnetic environments E1, E2, E3 according to

the standard EN55103-2 ed.2 Electromagnetic compatibility. Product family standard for audio, video,

audiovisual and entertainment lighting control apparatus for professional use. Part 2: Immunity.

The product (covers and cables) must not be exposed to a high frequency electromagnetic field higher

than 3V/m.

The installation company should check levels of possible interferences above the tested levels E1,E2,E3 given

by this standard (e.g. transmitters in surrounding area) before installing the equipment.

Emission of the equipment complies with the standard EN55032 Electromagnetic compatibility of multimedia

equipment – Emission Requirements according to class B.

The ArcSource Submersible II can be arranged in any position orientation. The LED module body is mounted

on a bronze bracket for tilt adjustment . Use the Allen key no.6 to adjust desired tilt position of the LED module

by means of two tilt locks (1). For fastening the ArcSource Submersible II to the flat surface use either three

holes or two semicircle slots which allows fine adjusting the fixture in a pan direction.